Installation of At-Spi2 Core
Install At-Spi2 Core by running
the following commands:
mkdir build &&
cd build &&
meson setup .. \
--prefix=/usr \
--buildtype=release \
-Dsystemd_user_dir=/tmp &&
ninja
A session bus address, normally available in an Xorg terminal, is
necessary to run the tests. The test suite also requires the glib
schemas of the package to be installed already. To test the
results, install the package first, then issue: ninja test. One test,
atk
, is known to timeout on some
systems. Another test, memory
, is
known to fail.
Now, as the root
user:
ninja install &&
rm /tmp/at-spi-dbus-bus.service
Command Explanations
--buildtype=release
:
Specify a buildtype suitable for stable releases of the package, as
the default may produce unoptimized binaries.
-Ddocs=true
: Use this switch if you
want to build the documentation. Note that you must have Gi-DocGen-2023.1 installed on your system.